What are the adjustment methods for tooth rubbing machines?

Just putTeeth rubbing machineInstalled in the movable mold groove and the mold groove, no iron or iron sheets under the mold are required. Just adjust the gap between the two friction plates, and then tighten and fix it. Adjust the gap between the two plates to tighten the blank. If the gap is too large, the blank will not be worn away. If the gap is too small, the blank will not enter the gap between the two plates. Similarly, the blank will not be wiped out. At the same time, adjust the gap between the upper and lower ends of the two friction plates by rotating the two fastening bolts and the fastening bolts. If the bolts are tightened and tightened, the gap between the end plate molds is small, the gap should be adjusted to the depth of the thread until the requirements are met.

Teeth rubbing machineThe friction surface between the sliding guide rail and the guide rail will wear out when the machine works for a long time. At this time, the surface of the upper and lower screw plates will become uneven, and the twisted threads will become oblique (that is, the screws or bolts can be screwed into the nut), and waste products will be generated, such as tapping threads, which require grinding or scraper, and the bottom surface and the fixing cavity will be recycled on the same plane. At present, it is possible to fix some thin pads or iron sheets on the dynamic friction plates, so that the two friction sheets are in the same plane, but this will make adjustments complicated and make the product quality unstable. Therefore, in case of severe wear,Teeth rubbing machineThe best way is to wear the machine.