What are the things you need to pay attention to when using Foshan screw tooth rubbing machine?

What are the things you need to pay attention to when using Foshan screw tooth rubbing machine?

The tooth rub machine, also known as the thread rub machine, is a professional screw production equipment, mainly forming screw marks.

Wire rubbing machines have a variety of specifications of wire rubbing machines, such as automatic wire rubbing machines, flat wire rubbing machines, semi-automatic wire rubbing machines, fully automatic wire rubbing machines, high-speed wire rubbing machines, etc. Our company's existing two-hand wire rubbing machines are fully automatic teeth rubbing machines, with models such as 003,004, 4R-35, 12R-120 and other screw wire rubbing machines.

Its characteristics are: the wire rub machine is light, flexible, efficient, and has advantages that other similar equipment cannot replace. The wire rub machine avoids the limitations of lathes, drilling machines or manual tapping, which saves time, effort, and is not easy to rot teeth. The products produced by the wire rub machine are suitable for various industries, and the most widely used are the electronics industry, gold industry, machinery industry, furniture industry, etc. The figures of screws can be seen everywhere in life.

However, no matter which kind of wire rub machine is used, some necessary matters should be paid attention to during use to prevent accidents.

Things to note when using a screw tooth rubbing machine are:

1. Before driving, you should carefully check whether all parts are normal, and whether the wire rubbing plate is balanced. Only after trial rubbing is normal before production can be carried out.

2. All protective devices on the tooth rubbing machine should be intact and should not be disassembled at will.

3. During operation, you must not contact the workpieces and wire rubbing boards in operation with your hands. It is strictly forbidden to make adjustments during the machine.

4. Before stopping the wire rubbing, the blank supply should be stopped first. Only when there is no blank between the wire rubbing boards can the power supply be cut off.

5. If the machine is shut down due to temporary power outage or other faults, and there is a blank in the wire rubbing board, it should be eliminated according to the prescribed method and the machine must not be forced to start.