After reading the following article, I believe everyone will have a better understanding of the operation of the silk rub machine.

As we all know, if we want to produce high-quality and qualified screws, we have to use this one of oursWire rubbing machineNot only that, there are many specifications for wire rubbing machines, such as fully automatic, semi-automatic, flat rollers and high-speed. Nowadays, the mechanical industry will basically use wire rubbing machines, so the problem comes. What should we pay attention to when operating wire rubbing machines? The editor is sure that many people are not clear about this. Let the editor explain in detail below.

First of all, we should check and install the grounding wire correctly before using the wire rubbing machine. During work, we should pay attention to the joint bearings at the 2nd end of the main link. If we find abnormal noise in the wire rubbing machine, we must stop refueling immediately. Secondly, we should pay attention to the point that the oil pipe of the wire rubbing machine is smooth in daily work. If there is any unobstructed situation, we should stop the machine immediately to avoid damage to the wire rubbing machine. After connecting the wire rubbing machine to the power supply, we must first turn on the oil pump motor. When the completely cold pipe outlet is released, it means that the electrical wiring of the entire machine tool is correct. Finally, we should replace and clean the oil and filter in the oil tank of the wire rubbing machine every month. This is to better protect the drying problem of lubricating oil in the wire rubbing machine. This is also one of the key points of the wire rubbing machine. Often, some small problems that are not paid attention to in normal times are fatal reasons for the wire rubbing machine.