Things to note when operating multi-station cold heading machine

Multi-stationCold heading machineThe cold heading method is used to transfer the optical disc element or rod material through the roller transmission, feeding, cutting, pressing ball, pressing angle, punching, and completing several processes in one machine. The cold heading station is arranged horizontally, with the characteristics of accurate positioning, stable operation, and convenient maintenance.

Things to note when operating multi-station cold heading machine

1. Do it before work:

(1) Check that the knife plate, cutting tool rod, punch, die, etc. should be intact and free of cracks, and be properly installed and securely tightened.

(2) After adjusting the cutting mechanism, the gap between the die clamp must be checked. It is strictly forbidden to start the equipment without inspection.

(3) When the cutting tool rod has been folded, the roller in the cam groove must be removed before the equipment can be jogated.

(4) Carefully check whether the equipment safety protection device is intact to prevent violent vibration from loosening and causing failure.

(5) Check whether the oil circuit of the lubrication cooling system of the cold heading machine is unobstructed. If there are foreign objects, clean them immediately. If the cold heading forming oil is insufficient, add them in time.

2. Do it at work:

(1) When starting the equipment, the main motor is only enabled to drive the flywheel to rotate when the feeding device is disconnected. Only when the flywheel is fully speeded can the feeding device be turned on. When stopping the equipment, the feeding device should be disconnected first and then the main motor should be stopped.

(2) Do not stop the slider at the "dead point". If the slider is parked at the "dead point", only manual rotation of the flywheel is allowed to correct it, and the equipment is not allowed to be activated.

(3) The processed rod or plate material must be clean, and the burrs on the material head must be worn off, and there must be no flat material.

(4) Pay attention to the working condition of the disc material rack. If you find chaos, stop the vehicle immediately. When the disc material is almost finished, the material tail should be taken out of the disc material.

3. After work, do it:

(1) Turn off the systems of the multi-station cold heading machine in turn, and then cut off the power supply.

(2) Wipe the cold heading machine clean and apply anti-rust oil on the work counter.

(3) Keep records after each operation or maintenance.

(4) If a fault occurs, the cold heading of multiple stations must be stopped immediately to find out the cause and eliminate hidden dangers.