Several operating methods for adjusting teething machine

according toTeeth rubbing machineThe processing requirements for the required workpieces are to be selected.

Turn the automatic and manual knobs to manual, adjust the right gear to the rear position according to the forward or back buttons.

Place the workpiece in the center of the 2 rollers, adjust the position of the right tapered surface until the workpiece is clamped, then adjust the position (when the 2 wheels feed the same scale and clamp the workpiece), and then fix the positions of the 2 rollers.

AdjustmentTeeth rubbing machineAfter the wheel is positioned, the workpiece can be processed. At the jog, the continuous running button runs the continuous operation panel, and the left axis knob runs continuously to the left and right cones, and then automatically and automatically manual the knob. Press the start button, the right cone will automatically move slowly to feed the left handwheel. The right wheel adjusts the feed, and the required diameter of the workpiece friction is expanded so far (this time scale is 2, the feeding handwheel should prevent the workpiece from deforming. In order to maintain the same lock feeding handwheel, the whole machine is used.

There are 3 fine-tuning knobs outside the right conical hydraulic cylinder, namely the stopwatch timer, the fast and slow sensor and the roller timing sensor. Their functions are as follows:

Stop sensor: After controlling the length of the tool holder, the knife will be longer. There is a residence timer on the control panel to adjust.

Slow motion sensor: The control roller can slowly move to the left when clamping the workpiece. The speed control valve in the speed reduction circuit of the oil pressure system of the grinder adjusts the slow motion speed, prevents the workpiece from deforming and extends the wheel life.

Teeth timing sensor: Controls the correct cone to move to the vertex on the left. When the roller moves to this position, rub the teeth and start rubbing the teeth, and the relay starts timing.

Ground foot switch function: before conversion, becauseTeeth rubbing machineIt is manual discharge. When the operator fails to fit the workpiece, the relay stay time and the right cone begins to shift to the left. The operator can press the pedal switch and return to the original position roller.