How to adjust the teether

Just putTeeth rubbing machineInstalled in the moving die groove and the fixed die groove, no thin pads or iron sheets are required under the mold. Just adjust the gap between the 2-wire plate and then tighten and fix it. Adjust the gap between the 2-plate so that the blank can be pressed just by too large, and the blank will not be rubbed and fall off. If the gap is too small, the blank will not enter the gap between the 2-plate, and the blank will not be rubbed and fall off. At the same time, adjust the gap between the upper and lower end surfaces of the 2-wire plate by rotating the 2-wire plate tightening bolts and the tension bolts. If the tightening bolts are tightened a little, the gap between the tail plate mold becomes smaller, and the gap should be adjusted to the depth of the rubbing thread until it meets the requirements.
　　
whenTeeth rubbing machineDuring long-term work, the friction surface between the sliding guide rail and the body guide rail will wear and tear. At this time, the upper and lower wire rubbing plates will have uneven surfaces, causing the rubbing thread to produce inclined lines (i.e. the screws or bolts cannot be screwed into the nut), and waste threads will be produced, such as self-tapping screws, and grinding or scraper is needed to restore the bottom surface to the same plane as the fixed mold groove. For the time being, some thin pads or iron sheets can be appropriately placed on the moving wire rubbing plate to make the two wire rubbing plates on the same plane, but this will make the adjustment complicated and make the product quality unstable. For this reason, when the wear is severe, the best method is to grind or scraper.