Use and maintenance of teeth roller

1.Tooth RollerThe cooling liquid must be made of water-soluble emulsified coolant. Oil-based coolant is strictly prohibited, and ordinary lubricating oil should not be replaced.

2. When there is no coolant, rolling and processing threads are strictly prohibited.

3. The ends of the steel bars to be processed should be flat and must be discharged with a toothless saw. It should be round and straight within the length of the end 500mm, and bending is not allowed, and the ends of the air cutting or cutting machine are not allowed to be processed directly.

4. The feed should be uniform during initial cutting and do not advance sharply to prevent the blade from cracking.

5. The slideways and sliders should be cleaned regularly and oiled.

6. Iron filings should be cleaned in time.

LargeTooth Roller

Folding and re-grinding and replacement

1. When cutting a certain number of steel bars with a rib peeler, the blade will become dull. At this time, the rib peeler should be removed and the front edge surface should be polished 0.2-0.3mm (it is strictly forbidden to sharpen the top surface of the blade), and then re-used after installation.

2. When the rib peeling blade edge cracks and cannot be cut normally, a new blade can be replaced.

3. After the wire rolling wheel rolls a certain number of wire heads, if the wear-tooth shape is damaged and qualified wire heads cannot be rolled out, a new wire rolling wheel should be replaced in time.

4. When replacing a new wire roller, the washer for adjusting the pitch must be installed correctly, otherwise it will not work normally.

Equipment Features:

(1) Simple operation, hydraulic and electrical control, no professional technician is required, and the machine can be turned on in ten minutes;

(2) Expand the cross-sectional area of ​​the end of the steel bar by 15-20 percentages, so that the base diameter of the thread processed into is not less than the diameter of the steel bar base material, and the tensile strength of the steel bar can be exerted by 110 percentages.

(3)Tooth RollerHigh production efficiency, each shift can upset 300-500 heads;