How to adjust the center axis position of the tooth roller

(1) After the wire rolling wheel is installed on the 2 spindle, check that the spindle is feeding, the 2 wire rolling wheels should not be touched.
(2) Loosen the lock nut of the center distance adjustment handle of the tail of the movable spindle seat.
(3) Adjust the movable spindle seat for feeding.
(4) Shake the center distance adjustment handle so that the two-roller wheel profile can be embedded in the workpiece thread.
(5) When the thread rolling wheel does not fully match the thread of the standard specimen, the pulley shaft can be shaken and the spindle can be driven to make the two-axis thread rolling wheel completely match the thread of the standard specimen, and finally fix all loose places.

Preventive maintenance procedures:
1. Pay close attentionTooth RollerFor lubrication of all parts of the equipment, refuel during shifts according to the lubrication instructions chart to ensure that all parts of the equipment are well lubricated.
2. During work, you must not remove the safety protection device and open the door cover of the transmission of the oil tank of the distribution box for work without authorization.
3. All operating devices and slider hammer head knife holders should be placed in non-working positions according to the instructions; the electrical source should be turned off.