How to maintain a tooth roller in daily life

Tooth RollerIt is a multi-functional cold rolling forming machine tool. It is mainly divided into three types: manual, semi-automatic, and fully automatic. As a commonly used processing equipment, its maintenance cost is high, the maintenance requirements are relatively complex, the dimensions are stable, and the accuracy is high. It can be produced according to the instrument, precision screw, and fixed strip rolling formula. Daily maintenance methods:

1. It is not allowed to tap or straighten the workpiece on the chucks or bed guides, and tools or workpieces are not allowed to be placed on the bed surface.

2. Before starting, check whether the workpieces on the machine tool are clamped. Place the handles of each gear changer in the low speed gear to prevent the lathe from being damaged due to sudden impact during driving. After starting. The spindle should be idle at a low speed of 1-2mm, so that the lubricating oil should be evenly distributed to all places (more important in winter), and can only work after the lathe is running normally.

3. When turning cast iron and chip-like workpieces, the lubricating oil on the guide rail should be wiped off to avoid damaging the guide rail surface.

4. When the spindle needs to change speed during the operation of the tooth roller, stop the machine first. Change the position of the feed box handle to be performed at low speed.

5. When using cutting fluid, lubricating oil must be applied to the lathe guide rail. The cutting fluid in the cutting fluid pump should be replaced regularly.

6. In order to maintain the accuracy of the lead screw, the automatic tooth rolling machine shall not use the lead screw for automatic cutting except for the threads.

7. When fully automatic tooth roller clamps heavier workpieces, wooden boards should be used to protect the bed surface. If the workpiece is not removed when you get off work, jacks should be used to support it.

8. After get off work, the chips and cutting fluid on the lathe and around the lathe should be removed. After cleaning, lubricating oil should be added to the surface of the guide rail as required, tail seat sleeves and lead screws, and the nut lubrication can be refueled once per shift. Since the long screws and light rods have high speeds and poor lubrication conditions, you must pay attention to refueling every shift, shake the bed saddle to the rear end of the car, and turn off the power.

9. After the turning tool is worn, sharpen it in time. Continuing cutting with a blunt knife will increase the lathe load and even damage the machine tool.

Foshan Heling Machinery Equipment Co., Ltd. (hereinafter referred to as Heling Company) is a comprehensive industrial company integrating new product research and development, manufacturing and sales. Faced with the 21st century of rapid development of technology, it has been constantly innovating and bravely developing, and has won the market with high-quality products, extensive marketing network and excellent after-sales service.