Heling Machinery teaches you how to maintain the tooth roller

Tooth RollerIt is a multi-functional cold rolling forming machine tool. It is mainly divided into three types: manual, semi-automatic, and fully automatic. As a commonly used processing equipment, its protection cost is high and the protection requirements are relatively messy.
Daily maintenance content of tooth roller:

1. After the turning tool is worn, it should be sharpened in time. Continuous cutting with a blunt knife will increase the lathe load and even damage the machine tool.

2. It is not allowed to tap or straighten the workpiece on the chucks or bed guides, and no things or workpieces are allowed to be placed on the bed surface.

3. When fully automatic tooth roller clamps heavier workpieces, wooden boards should be used to protect the bed surface. If the workpiece is not removed when you get off work, use a jack to support it.

4. When turning cast iron and chip-like raw materials, the smooth oil on the guide rail should be wiped off to avoid grinding the guide rail surface.

5. When using cutting fluid, apply smooth oil to the lathe guide rail. The cutting fluid in the cutting fluid pump should be replaced regularly.

6. In order to maintain the accuracy of the lead screw, imported tooth rolling machines must not use a lead screw for automatic feeding except for the car thread.

7. When the spindle needs to change speed during the operation of the tooth roller, the machine must be stopped first. Change the position of the feed box handle must be performed at low speed.

8. After get off work, the chips and cutting fluid on the lathe and around the lathe should be removed. After cleaning, the smooth oil should be added to the surface of the guide rails, the tail seat sleeve and the lead screw. The smooth nut can be refueled once every shift. Because the speed of the long screw and the light rod are high and the smooth conditions are poor, pay attention to refueling every shift, and then shake the bed saddle to the rear end of the car and close the power supply.

9. Before starting, check whether the workpieces on the machine tool are clamped. Place the handles of each gear changer in the low speed gear to prevent the lathe from being damaged due to sudden impact during driving. After starting. The spindle should be idle at a low speed of 1-2mm, so that the smooth oil can be evenly distributed throughout the ground (more important in winter), and only after the lathe works properly.

Foshan Heling Machinery Equipment Co., Ltd. (hereinafter referred to as Heling Company) is a comprehensive industrial company integrating new product research and development, manufacturing and sales. Its main products include automatic cutting and scrubbers, high-speed scrubbers, and tooth rollers. Faced with the rapid development of technology in the 21st century, our company has been constantly innovating and pioneering, and has won the market with high-quality products, extensive marketing network and excellent after-sales service.