The most convenient maintenance method for tooth rolling machines

Tooth RollerIn fact, there is a common name. It is also known as the wire rolling machine. The wire rolling machine is a multi-functional cold rolling forming machine tool. The wire rolling machine can roll thread, straight and twill mark on the workpiece under the cold state within its rolling pressure range; rolling of straight, helical teeth and oblique spline gears; straightening, shrinking diameter, rolling and various forming rolling.

Maintenance method of tooth roller:

1. It is not allowed to tap or straighten the workpiece on the chucks or bed guides, and tools or workpieces are not allowed to be placed on the bed surface.

Tooth Roller

2. When turning cast iron and chip-like raw materials, the smooth oil on the guide rail should be wiped off to avoid grinding the guide rail surface.

3. In order to maintain the accuracy of the lead screw, imported tooth rolling machines shall not use the lead screw for active injection except for the threads.

4. After the turning tool is worn, sharpen it in time. Continuing cutting with a blunt knife will add lathe load and even damage the machine tool.

5. When using cutting fluid, apply smooth oil to the lathe guide rail. The cutting fluid in the cutting fluid pump should be replaced regularly.

6. When the spindle needs to change speed during the operation of the tooth roller, the machine must be stopped first. The position of the feed box handle must be changed at low speed.

7. When clamping heavier workpieces with full active tooth roller, wooden boards should be used to maintain the bed surface. If the workpiece is not removed during get off work, use a jack to support it.

8. Before starting, check whether the workpieces on the machine tool are clamped. Place the handles of each gear changer in the low speed gear to prevent the lathe from being damaged due to sudden impact during driving. After starting. The spindle should be idle at a low speed of 1-2mm, so that the smooth oil can be evenly distributed throughout the ground (it is more important in winter), and the lathe can only work after it works properly.

9. After get off work, the chips and cutting fluid on the lathe and around the lathe should be removed. After cleaning, the smooth oil should be added to the surface of the guide rail according to regulations. The tail seat sleeve and lead screw should be added. The smooth nut can be refueled once every shift. Because the speed of the long screw and the light rod are high and the smooth conditions are poor, you must pay attention to refueling every shift, and then shake the bed saddle to the rear end of the car to close the power supply.

Foshan Heling Machinery Equipment Co., Ltd. (hereinafter referred to as Heling Company) is a comprehensive industrial company integrating new product research and development, manufacturing and sales. Its main products include automatic cutting and scrubbers, high-speed scrubbers, and tooth rollers. Faced with the rapid development of technology in the 21st century, our company has been constantly innovating and pioneering, and has won the market with high-quality products, extensive marketing network and excellent after-sales service.