If you want to improve the working efficiency of the cold heading machine, you must do the following precautions before using it.

As we all know, cold heading machine is a special equipment mainly used for piers and is specially used to produce nuts, bolts and other fasteners. The cutting mechanism of the cold heading machine adopts computer design and processing cams to achieve the purpose of smooth and fast cutting. The roller shaft of the cutting parts is supported by two-way to ensure that the scissor rod has sufficient steelness. Each clamp of the clamp transmission system has a pair of planetary gears, which can control the flip and translation of the calipers to achieve accurate cutting and smooth cutting. In order to avoid problems in the use of the cold heading machine, the matters that should be paid attention to during use are introduced in detail here. Before using the cold heading machine, use smooth oil or pressing oil to fill it. Please refer to the smooth system description of the oil capacity and viscosity index.

Before starting the cold heading machine, you must also check whether the wire joints are loose and whether the machine screws are loose. After the cold heading machine has worked for a period of time, check again whether the screws of each part are loose and whether the oil circuit is unblocked. This is necessary. When the cold heading machine is officially started, the smooth pump should be started first until the smooth indicator blue light is on, so that you can know whether the smooth pump operation is normal, and then start the main motor to check whether the machine is running smoothly. After everything is normal, then check the yes by a single stroke. No, when parking is normal, the main sliding platform of the cold heading machine can be parked behind for easy adjustment and operation. Otherwise, the cam viewpoint position of the electrical appliance operated by the parking position must be adjusted. This position will need to be adjusted due to different speeds. When performing inch operation, it should be moved once per inch, so there will be no abnormality in the adjustment of the clutch. When the machine is equipped with a speed change device, the machine should try to perform inch school bus operations at a slow speed to reduce the sliding wear of the clutch when it is driven during high-speed operation.