After reading the following article, we not only learned about the silk rub machine, but also learned about its several machine adjustment knowledge.

Everything has an order. If you want to understand the wire rubbing machine, of course, we must first start by understanding the wire rubbing machine. The wire rubbing machine is a machine that specializes in the manufacturing of screws. Of course, according to the needs of different industries, the wire rubbing machine also has many specifications to choose from, such as: automatic wire rubbing machine, semi-automatic wire rubbing machine, fully automatic wire rubbing machine, high-speed wire rubbing machine, etc. The sensitivity and high efficiency of the wire rubbing machine cannot be replaced by other similar equipment. Its appearance not only prevents the limitations of lathes and manual tapping, but also achieves the advantages of saving time, saving effort and not easy to rot teeth. We first understand the use of the wire rubbing machine, and now we will have a deeper understanding of the adjustment steps of the wire rubbing machine.

Wire rubbing machineThere are the following steps for adjusting the machine. I hope you can read it carefully. The first is the local adjustment of the transmission. The main motor pulley of the wire rubbing machine has two levels of speed. If you need to adjust the speed, you must turn the handwheel and drive the lifting screw through the bevel gear pair to make the screw in a loose or tight state. The second is the adjustment of the feeding mechanism of the wire rubbing machine. Generally speaking, the hopper of the feeding mechanism is generally relatively stable and does not need to be adjusted. However, if the specifications need to be changed, the width of the material path needs to be adjusted according to the specifications. The third is the adjustment of the device for the wire rubbing machine, because the manufacturing accuracy of the wire rubbing machine is relatively high. When we use the new equipment, the wire rubbing board needs to be placed in the fixed wire wheel groove and the moving wire wheel groove to tighten. After that, you can rub out fine and qualified products. The new machine also needs to adjust the gap between the upper ends of the two wire plates, and after confirming the tightening, you can start the wire rubbing work. Finally, adjust the smooth system of the wire rubbing machine. The smooth system is divided into two aspects: transmission smoothness and operation smoothness. We should regularly clear the transmission slide system and add gear oil, guide rail oil, hydraulic oil, etc. This can make the equipment operate smoothly and reduce process errors. For the working slide rail system, special tapping oil should be used to reduce the direct contact between the wire rubbing machine and the workpiece. This can not only reduce the loss of the equipment, but also reduce the production costs of the enterprise. The above are some knowledge we need to know about the wire rubbing machine. Do you still want to know more about the mechanical equipment?