How to operate the tooth rub?

Teeth rubbing machineThe operation method is as follows:

Connect the power supply, press the start switch, start the tooth rubbing machine, check whether the tooth rubbing machine oil bottle is filled with lubricating oil and whether the rotation is normal.

Install a tooth rubbing board, which has 4mm, 6mm and 8mm, and the most commonly used is 4mm.

The produced samples can only be mass-produced after being inspected by the team leader.

The quality of the tooth rubbing machine should be checked for 5 to 10 minutes of production, and the nut can be used to check the quality of the tooth rubbing machine.

After work is finished, turn off the switch.

Precautions for operating the tooth rubbing machine:

The brightness of lighting equipment in the machine working environment is based on relevant local regulations.

Neither electrically conductive CO2 or ABC dry powder fire extinguishing equipment should be equipped near the machine.

You should read the operating instructions of this machine before operating the machine.

For those with older hair, they should use a hairband to tie their hair or wear a hard hat before operating it, or repairing the machine.

Keep the machine and nearby tidy, avoid too much oil stains on the ground and slippery, and remove obstacles around the machine that will affect operation.

When operating the machine, the electrical box cover and motor protective cover must be fastened, and the electrical wiring should be operated in accordance with the instructions and safely grounded.

Before repairing the machine, the power supply should be cut off first and only suitable tools can be used.

Those who wear loose clothes, unqualified clothes with too long sleeves, wear tie, slippers, and gloves are not allowed to operate or repair the machine.

When the machine is running and working, it cannot rely on the machine.

When adjusting the machine, you must use a manual flywheel or switch to make the machine rotate several times in an inch-moving manner to check whether there are any abnormalities in the machine, and you can turn it on and move it first to avoid accidents.

When an abnormality is found during operation, the machine should be shut down immediately to find out the cause and eliminate it in time.

Observe the oil circuit to be unobstructed at any time, refuel in time, and clean regularly.

Manufacturers shall not increase the diameter of the motor pulley without authorization in order to increase production capacity.