How to debug tooth rolling machine

Tooth RollerThe method of debugging messy teeth is as follows:

1.2 Debugging of shaft machines.

The 2 wheels need to be synchronously adjusted to configure the corresponding center plates with different specifications and outer diameters between the two wheels. When processing the threads, the workpiece is placed on the center plate, and the center height of the workpiece is consistent with the center height of the rolling die.

2.3 Debugging of shaft machines.

3 rolling dies are adjust the isosceles 3 corners, adjust the gap according to the size of the tube, adjust the teeth distance, and install one end of the bytes when installing the rolling die. Press A, B, and C clockwise to install it. Take a circular tube and insert it between the 3 wheels, turn it half a circle, take out the circular tube to check whether the pressure lines of the 3 wheels are connected to each other. If there is a gap, which wheel adjusts which wheel should be adjusted. 2 wheels are debugged and the other wheel is not debugged. The teeth adjustment needs to be squeezed multiple times according to the diameter of the pipe to adjust it to an ideal depth. Remember to test the pressure once, which wheel will be adjusted, which wheel will be damaged.