How to debug the automatic cutting tooth rubbing machine?

To debugAutomatic cutting and rubbing machine, you can follow the steps below:

1. Check the power supply: Make sure the tooth rubbing machine is properly connected to the power supply and the power supply is normal. If powered by a battery, make sure the battery is fully charged or replace with a new battery.

2. Check the switch: Make sure the switch of the tooth rubbing machine is in the correct position. Some tooth rubbing machines may have multiple gears or modes to make sure to select the correct settings.

3. Cleaning and Maintenance: Check the tooth rub for any impurities or clogs. Clean the bristles or brush heads and make sure they are not damaged or worn.

4. Check how to use: Make sure you use the tooth rubbing machine correctly. Read the instruction manual or refer to the manufacturer's advice to understand the correct way to use and techniques.

5. Try restarting: Sometimes, the tooth rubbing machine may experience operational problems or failures. Try turning it off, wait for a few minutes, and then restart.

6. Contact the manufacturer or after-sales support: If you try the above method and still cannot solve the problem, it is recommended that you contact the manufacturer or after-sales support department of the tooth rubbing machine. They may be able to provide professional technical support or further solutions.

Please note that when debugging the tooth rubbing machine, follow the manufacturer's advice and safety guidelines to avoid damage to the equipment or causing unnecessary dangers.